FAULT CODE
Fault code P0101
P0101 means the mass air flow (MAF) sensor reading does not match what the engine computer expects for the engine speed and load.
IS IT SAFE TO DRIVE?
Yes
Usually safe to drive, but performance may be reduced and the car can go into limp mode. 07494 227487

Supplied definitions
GENERIC - SAME MEANING ON ALL MAKES
- Mass or Volume Air Flow Sensor A Circuit Range/Performance
- Powertrain (engine, gearbox, emissions) · Standard definition
- Large vacuum leaks, Split Intake Air Boot or PCV Hose, Defective intake manifold gaskets, Mass Airflow Sensor (MAF), Mass Air Flow Sensor circuit and or wiring problems, Defective Barometric Pressure Sensor, Dirty or contaminated Mass Air Flow Sensing wire or filament, PCM software needs to be updated
- Powertrain (engine, gearbox, emissions) · Likely causes (brand-specific notes)
A generic code carries the same meaning on all makes, but the underlying causes and the repair procedure can still vary from car to car.
Definitions are reproduced as supplied by the data source. They describe what the code means, not what is wrong with your particular car.
What it means
P0101 means the mass air flow (MAF) sensor reading does not match what the engine computer expects for the engine speed and load.
Typical symptoms
- Engine light on
- Hesitation or flat spots
- Poor fuel economy
- Limp mode on some diesels
Safety guidance
Yes
Usually safe to drive, but performance may be reduced and the car can go into limp mode.
This advice is written for the vehicles above. A code lookup on its own cannot confirm that your vehicle is safe to drive - if you are unsure, stop somewhere safe and call the garage.
Common causes
- Dirty or contaminated MAF sensor
- Air leak between the sensor and the engine
- Blocked or wrongly fitted air filter
- EGR or boost leak on diesels
- Wiring or connector fault
How we diagnose and fix it
We compare the MAF reading with the expected value at idle and under load, check for intake and boost leaks, and test the sensor's supply and signal before replacing it.
Price guidance
Initial computer diagnostic check is £120. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work. Once the cause is found, the repair is quoted before any work starts, and any small extra parts a bigger repair needs are explained to you first. No surprises.
Frequently asked questions
Can I clean the MAF sensor?
Sometimes that helps, but a leak or EGR fault often causes the same code, so it is worth diagnosing first.
Also searched as: P 0101 · MAF sensor code · air flow meter fault
Related codes
Related services
Source: SAE J2012 standard definition; written by Inscripta Autotech.. Last reviewed 2026-11-04.
Look up another code
Get this checked
A fault code on its own does not confirm a diagnosis, and a code lookup cannot tell you whether your vehicle is safe to drive. Book a diagnostic and we will test the car in person.
How diagnosis is charged
- Initial computer diagnostic check: £120.
- Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work.
- Once the cause is found, we quote the repair and only carry it out once you agree.
No surprises: bigger repairs sometimes need small extra parts to finish the job to a high standard. We always tell you about these before they are fitted.
A booking request is not a confirmed appointment: the garage confirms availability with you, and any further work is agreed with you before it starts.