Monthly service plan: spread the cost over 12 months•Servicing, brakes and MOT in one plan•£5 off tyres and free puncture repairs for members•
See the plan

FAULT CODE

Fault code P0340

P0340 means the engine computer is not getting a valid signal from the camshaft position sensor (bank 1 or single sensor).

IS IT SAFE TO DRIVE?

Drive with caution

Starting can become unreliable. Get it checked before it leaves you stranded. 07494 227487

Camshaft position sensor on a cylinder head, fault code P0340

Supplied definitions

GENERIC - SAME MEANING ON ALL MAKES

Camshaft Position Sensor A Circuit Bank 1 or Single Sensor
Powertrain (engine, gearbox, emissions) · Standard definition

A generic code carries the same meaning on all makes, but the underlying causes and the repair procedure can still vary from car to car.

Definitions are reproduced as supplied by the data source. They describe what the code means, not what is wrong with your particular car.

What it means

P0340 means the engine computer is not getting a valid signal from the camshaft position sensor (bank 1 or single sensor).

Typical symptoms

  • Long cranking or no start
  • Rough running
  • Reduced power
  • Engine light on

Safety guidance

Drive with caution

Starting can become unreliable. Get it checked before it leaves you stranded.

This advice is written for the vehicles above. A code lookup on its own cannot confirm that your vehicle is safe to drive - if you are unsure, stop somewhere safe and call the garage.

Common causes

  • Failed camshaft sensor
  • Wiring or connector fault
  • Timing belt or chain problem
  • Damaged sensor target

How we diagnose and fix it

We scope the cam and crank signals together to check the sensor and confirm the timing is correct, then repair the wiring or replace the sensor.

Price guidance

Initial computer diagnostic check is £120. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work. Once the cause is found, the repair is quoted before any work starts, and any small extra parts a bigger repair needs are explained to you first. No surprises.

Frequently asked questions

Could it be my timing belt?

Sometimes. Comparing cam and crank signals shows whether the timing has moved.

Also searched as: P 0340 · cam sensor fault

Related codes

Related services

Source: SAE J2012 standard definition; written by Inscripta Autotech.. Last reviewed 2026-11-04.

Look up another code

Get this checked

A fault code on its own does not confirm a diagnosis, and a code lookup cannot tell you whether your vehicle is safe to drive. Book a diagnostic and we will test the car in person.

How diagnosis is charged

  1. Initial computer diagnostic check: £120.
  2. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work.
  3. Once the cause is found, we quote the repair and only carry it out once you agree.

No surprises: bigger repairs sometimes need small extra parts to finish the job to a high standard. We always tell you about these before they are fitted.

A booking request is not a confirmed appointment: the garage confirms availability with you, and any further work is agreed with you before it starts.

Send us your reg and fault code

Tell us the code and your registration and we will get back to you.

Fault code: P0340

This is a request, not a confirmed appointment. The garage will confirm availability with you.

Let’s get you back on the road.

SAME ROADS  A BRIGHTER TOMORROW