
FAILED FLASH · WATER INGRESS · BOARD REPAIR
Bricked and water-damaged ECU recovery
This page is for drivers and garages with an engine ECU that stopped working after a software flash went wrong, after water got in, or after a jump-start or bad tuning file. Before you buy a new unit, we try to recover your car's own ECU on the bench.
Signs you need this
- The car won't start after a software update or a flash that didn't finish
- The ECU stopped communicating after water got into it
- The car died after a jump-start or a battery fault
- The car runs badly or won't start after a tuning file was written
What we do
Failed or interrupted flashes
The firmware on MG1 and MD1 units is signed, so corrupt or altered software can leave the car not starting. We read the unit on the bench and restore a working copy of its software, using the backup we take first.
Water ingress and electrical damage
Water, a jump-start or a battery fault can damage the board itself. We clean and inspect the board, then repair failed components at board level where it can be done. If the board can't be saved but its memory can still be read, we can clone it to a matching donor instead.
Bad tuning files
If a tuning file has left the car running badly or not at all, we return the ECU to working software with all emissions equipment kept working.
We restore the vehicle's own ECU. We never remove a DPF, EGR or AdBlue system, turn an immobiliser off or change mileage.
How it works
- 1Tell us what happened and send the Bosch part number. We confirm the platform and how the unit has to be read.
- 2We check ownership: V5C logbook and photo ID with a matching name, or for trade jobs your garage details, the reg or VIN and the end customer's V5C on request.
- 3We take a full backup of whatever can be read from the unit before any work.
- 4We restore the software or repair the board, depending on the fault.
- 5We test the unit and confirm the result before it is fitted or posted back.
Makes covered
- Volkswagen
- Audi
- Skoda
- Seat
- Cupra
- BMW
- Mini
- Mercedes-Benz
- Peugeot
- Citroën
- Vauxhall
- Ford
Price
Price on request
Confirmed after we check the part number. No work starts until you agree the quote.
Frequently asked questions
My car died during a software update. Can it be saved?
Often, yes. In most cases a unit that stopped mid-flash can be read on the bench and its software restored. We confirm once we have checked it.
Can a water-damaged ECU be repaired?
Sometimes. We clean and inspect the board and repair damaged components where possible. If the board can't be saved, a clone to a matching donor may still be an option.
Do I need to send the whole car?
No. Most recovery work only needs the ECU, which you can post to us. If the fault still needs finding, bring the car in for the initial computer diagnostic check (£120) first.
Will my keys still work after recovery?
Yes. We restore your car's own ECU, so the immobiliser data stays with it.
How much does ECU recovery cost?
Pricing is on request and confirmed after we check the part number and the fault. No work starts until you agree the quote.
Good to know
Ownership is checked before any immobiliser or ECU security work. Drivers: V5C logbook plus photo ID with a matching name. Trade customers: garage name, contact, the reg or VIN, and the end customer's V5C on request.