Monthly service plan: spread the cost over 12 months•Servicing, brakes and MOT in one plan•£5 off tyres and free puncture repairs for members•
See the plan

FAULT CODE

Fault code P0301

P0301 means the engine computer has detected misfires in cylinder 1. Because it is a single cylinder, the cause is usually something specific to that cylinder.

IS IT SAFE TO DRIVE?

Drive with caution

Drive gently and avoid heavy loads. If the engine light flashes, stop hard acceleration straight away to protect the catalytic converter. 07494 227487

Ignition coils lifted out of a petrol engine during misfire diagnosis, fault code P0301

Supplied definitions

GENERIC - SAME MEANING ON ALL MAKES

Cylinder 1 Misfire Detected
Powertrain (engine, gearbox, emissions) · Standard definition
Worn out spark plugs, ignition wires, coil(s), distributor cap and rotor (when applicable), Incorrect ignition timing, Vacuum leak(s), Low or weak fuel pressure, Improperly functioning EGR system, Defective Mass Air Flow Sensor, Defective Crankshaft and or Camshaft Sensor, Defective Throttle Position Sensor, Mechanical engine problems (i.e.—low compression, leaking head gasket(s), or valve problem
Powertrain (engine, gearbox, emissions) · Likely causes (brand-specific notes)

A generic code carries the same meaning on all makes, but the underlying causes and the repair procedure can still vary from car to car.

Definitions are reproduced as supplied by the data source. They describe what the code means, not what is wrong with your particular car.

What it means

P0301 means the engine computer has detected misfires in cylinder 1. Because it is a single cylinder, the cause is usually something specific to that cylinder.

Typical symptoms

  • Rough idle or vibration
  • Engine light on, sometimes flashing
  • Loss of power
  • Engine runs unevenly when cold

Safety guidance

Drive with caution

Drive gently and avoid heavy loads. If the engine light flashes, stop hard acceleration straight away to protect the catalytic converter.

This advice is written for the vehicles above. A code lookup on its own cannot confirm that your vehicle is safe to drive - if you are unsure, stop somewhere safe and call the garage.

Common causes

  • Failed ignition coil or spark plug on cylinder 1
  • Faulty or sticking injector on cylinder 1
  • Wiring fault to that coil or injector
  • Low compression on cylinder 1

How we diagnose and fix it

We confirm the misfire on live data, then swap-test the coil and plug to another cylinder to see if the misfire follows. Injector balance rates and wiring are checked, and a compression test is done if the parts check out.

Price guidance

Initial computer diagnostic check is £120. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work. Once the cause is found, the repair is quoted before any work starts, and any small extra parts a bigger repair needs are explained to you first. No surprises.

Frequently asked questions

Which cylinder is number 1?

It depends on the engine. On most transverse four-cylinder engines it is at the timing belt or chain end, but we confirm it for your engine.

Will a new coil fix it?

Often, but not always. Swap-testing shows whether the coil is really at fault before you pay for one.

Also searched as: P 0301 · cylinder 1 misfire

Related codes

Related services

Source: SAE J2012 standard definition; written by Inscripta Autotech.. Last reviewed 2026-11-04.

Look up another code

Get this checked

A fault code on its own does not confirm a diagnosis, and a code lookup cannot tell you whether your vehicle is safe to drive. Book a diagnostic and we will test the car in person.

How diagnosis is charged

  1. Initial computer diagnostic check: £120.
  2. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work.
  3. Once the cause is found, we quote the repair and only carry it out once you agree.

No surprises: bigger repairs sometimes need small extra parts to finish the job to a high standard. We always tell you about these before they are fitted.

A booking request is not a confirmed appointment: the garage confirms availability with you, and any further work is agreed with you before it starts.

Send us your reg and fault code

Tell us the code and your registration and we will get back to you.

Fault code: P0301

This is a request, not a confirmed appointment. The garage will confirm availability with you.

Let’s get you back on the road.

SAME ROADS  A BRIGHTER TOMORROW