FAULT CODE
Fault code P0300
P0300 means the engine computer has detected misfires on more than one cylinder, or misfires it cannot pin to a single cylinder. Fuel in at least one cylinder is not burning properly.
IS IT SAFE TO DRIVE?
Drive with caution
If the engine light is flashing, ease off and avoid hard acceleration: heavy misfiring can overheat and damage the catalytic converter. If the car shakes badly or loses power, stop when safe and call us. 07494 227487

Supplied definitions
GENERIC - SAME MEANING ON ALL MAKES
- Random/Multiple Cylinder Misfire Detected
- Powertrain (engine, gearbox, emissions) · Standard definition
- Worn out spark plugs, ignition wires, coil(s), distributor cap and rotor (when applicable), Incorrect ignition timing, Vacuum leak(s), Low or weak fuel pressure, Improperly functioning EGR system, Defective Mass Air Flow Sensor, Defective Crankshaft and or Camshaft Sensor, Defective Throttle Position Sensor, Mechanical engine problems (i.e.—low compression, leaking head gasket(s), or valve problem
- Powertrain (engine, gearbox, emissions) · Likely causes (brand-specific notes)
A generic code carries the same meaning on all makes, but the underlying causes and the repair procedure can still vary from car to car.
Definitions are reproduced as supplied by the data source. They describe what the code means, not what is wrong with your particular car.
What it means
P0300 means the engine computer has detected misfires on more than one cylinder, or misfires it cannot pin to a single cylinder. Fuel in at least one cylinder is not burning properly.
Typical symptoms
- Rough or shaky idle
- Hesitation or jerking when accelerating
- Loss of power
- Engine light on, or flashing under load
- Higher fuel use
Safety guidance
Drive with caution
If the engine light is flashing, ease off and avoid hard acceleration: heavy misfiring can overheat and damage the catalytic converter. If the car shakes badly or loses power, stop when safe and call us.
This advice is written for the vehicles above. A code lookup on its own cannot confirm that your vehicle is safe to drive - if you are unsure, stop somewhere safe and call the garage.
Common causes
- Worn spark plugs or failing ignition coils
- Air (vacuum) leaks after the mass air flow sensor
- Low fuel pressure or dirty or leaking injectors
- Faulty crank or cam sensor signals
- EGR valve stuck open
- Mechanical problems such as low compression or valve faults
How we diagnose and fix it
We read live misfire counters for every cylinder to see whether one cylinder or several are affected, then test ignition, fuel trims, fuel pressure and injectors. If the pattern points to a mechanical cause, we run a compression or leak-down test before any parts are fitted.
Price guidance
Initial computer diagnostic check is £120. Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work. Once the cause is found, the repair is quoted before any work starts, and any small extra parts a bigger repair needs are explained to you first. No surprises.
Frequently asked questions
Can I keep driving with P0300?
Short, gentle journeys only, and not if the engine light is flashing. Ongoing misfires can damage the catalytic converter, which costs far more than the original fault.
Is P0300 always spark plugs?
No. Plugs and coils are common, but air leaks, fuel delivery and sensor faults cause it too. Live data shows which before anything is replaced.
Also searched as: P 0300 · P0300 misfire · random misfire code
Related codes
Related services
Source: SAE J2012 standard definition; written by Inscripta Autotech.. Last reviewed 2026-11-04.
Look up another code
Get this checked
A fault code on its own does not confirm a diagnosis, and a code lookup cannot tell you whether your vehicle is safe to drive. Book a diagnostic and we will test the car in person.
How diagnosis is charged
- Initial computer diagnostic check: £120.
- Deeper testing (oscilloscope, wiring and component tests) is not included: it is charged separately and agreed with you before any work.
- Once the cause is found, we quote the repair and only carry it out once you agree.
No surprises: bigger repairs sometimes need small extra parts to finish the job to a high standard. We always tell you about these before they are fitted.
A booking request is not a confirmed appointment: the garage confirms availability with you, and any further work is agreed with you before it starts.